How To Make a Canon Minecraft TNT in 9 Steps

1
164

How To Make a Canon Minecraft TNT (7/9 steps)

Step 7: Raw Distributors and Additional Blocks

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

For the next step, you will add little more solid blocks in the positions you can see the orange wool. This acts as a color code, so I can show you more easily which blocks, I mean, in this case for you these blocks would be the ones you chose as your solid blocks. Then add the dispensers. Each of the must be between the orange blocks and a block above them as well. Also, you will pass your entire line of these backs by that of the original design so that the latest TNT will touch the sourceblock of water. In this case, it is not bad that DTT is already started when you put it. Also this time do not place your repeater next to the tnt launch, which is going to be at the window. You can see it in the picture. After that, add blocks to where the green wool is on the third photo. This is a 2×3 field that will hold aditional redstone later. Finally add blocks in the position where the red wool is on the picture. This will be where the distributor is placed later in and it also holds some redstone.