How To Make a Canon Minecraft TNT in 9 Steps

1
73

How To Make a Canon Minecraft TNT (9/9 steps)

Step 9: The Clock

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

How to make a Canon minecraft TNT

This is the last step in my tutorial on DTT canons. To do this, you will connect up to 11 repeaters leading up to the thin end portion of the orange wool segment. This will make the whole set complete ticks. Then connect a line of redstone dust from the redstone dust of the orange segment back around the repeat as well as link the two lines up with another repeater as seen in picture 3. This relay will control how fast your Canon is In shooting: the more the number of ticks, the rate is low, it pulls. Finally add a block with a button at the end of the repeater line. Then fill the dispensers and press the button. Check your work again and press the Start button launches DVB-T. To stop this launch simply remove the connection and the speed control repeater until the redstone signal has fully closed, and then replace it. Thank you for taking your time on my tutorial, I hope you liked it and have a good time with your new Canon TNT “(s)